10/9/2019 Ping Golf Club Serial Number Lookup
Background I ordered my Ping i20s after a custom fitting from AG back in the first week of May- they recommended the CFS shaft and 3 degrees flatter lie angle (brown dot). These arrived last week of May and prior to payment in full, i decided to hit some balls with the new 7 iron and get the lie angle re-checked manually with piece of tape (with markings in degrees ranging +3, +2, +1, 0, -1, -2, -3 stuck to sole of club head. After hitting a couple of shots on a board that felt like hitting off laminate flooring, the AG rep looked at the mark and said it was 'fine'. Luckily, I did some homework and knew right away that the mark is not on the centre of the tape- the mark was in fact closer to the heel of the club sitting between -1 and -2. It became clear to me that the fitting was wrong and I needed the 4 degree flatter which were gold dot, i think this is the max Ping can provide for flat lie angle without bending the hosel of the club head. The rep tried to persuade me that the 1 degree will make no difference but I wasn't convinced so ask that they send them back and get me the same clubs but in gold dot. He wasn't pleased and tried to talk me out but I made it clear I did not want them even if they offer a significant reduction in price. The suspected Fraud My new Ping i20s arrived yesterday and I went to collect them today.
I must admit, i was in a bit of a rush so trusted that AG got my order correct this time. I counted the number of clubs were right and then paid the balance. When I got home, I noticed that the new clubs had the sticky clear protector on them except the 7 iron which had been used. The 7 iron had marks on the club face which were consistent with someone trying them out. However I note that the colour of dots have changed to gold and not the brown dot I tested out. This leads me to believe that AG have not bothered to send them back and in an effort to decieve me they have painted over the brown dots with gold marker or paint.
I'm trying to think this through and gather my thoughts before I make any accusations so wondered if anyone can offer me some advice/ answer to the following queries:- 1/ Is it possible to give me back the same 7 iron with 1 degree flatter without changing the clubhead? I.e just bending hosel but how can we explain the gold dot? 2/ if the above is true and AG and or Ping bent the clubs then would painting over the brown dot to show gold dot be acceptable? Cheers, Read this as well. Not sure what you're expecting here, but having been through the process at the Gainsborough factory a few times, it initially surprised me how this happened.
After hitting a few shots (quite a lot really!) they then took the clubs, put them into a jig, then basically belted them with a plastic mallet until they were in the correct lie and loft. Once complete they took a small can of model makers enamel paint of the correct hue and painted over the original colour dot. Is that what you're implying has happened to you? If so, it's certainly what I would have expected. Thanks for all the feedback, I thought that the clubheads with hosel for the different lie angles casted during the manufacturing process. Therefore, i had expected to get new set of clubheads with the correct lie angle casted and had not anticiapted that PING would just bend them to the gold dot spec and paint over the original brown dot. Having seen the general responses above and talking to Ping Rep, i am happy that no foul play has been committed by AG or PING!
So all is well. Appologies for the defamation from one ignorant golfer! That's the advantage of buying a set of Pings over any other manufacturer All Nike, Taylormade, Calloway etc irons are cast when they're made as its a lot cheaper for the companies to mass produce them in places such as China, and these can't be altered after custom fitting, you would have to buy new irons if you wanted the lie angle changing. Whereas as Ping manufacture all their own clubs themselves, each club has a custom fitting joint on the hostel allowing the lie angle to be changed totally free of charge, all you have to pay is??20 carriage to Gainsborough and back.
This also enables you, even after your set of pings isn't the current model any more you can always add to your set, or buy replacements matching to your set, all be it at a slightly higher price than you would have paid originally as any non current models have to be made especially in America and shipped over. Unlike with Nike, taylormade, Callaway etc as they have their clubs cast in china on a mass production level, once a model isn't current any more you wouldn't be able to buy a replacement or add to your set even if you wanted to, you'd end up with a miss matched set My advice is always buy Pings, i did myself 4 years ago and hsve t looked back, a set if pings really can be for life, and their customer service is exemplary.
I bought my spouse some new ping clubs. I'm afraid they may be fake. I dont want to give them as a present until I am sure.
The serial number on the clubs is 4k4757i. Anyone help me out in finding out if they are real? I hope I havent blundered. He warned me once before about this but I was determined to find him a deal and my neighbor seems to think they may be fake. Now I may be in hot water and would like to resolve it before he finds out.if they are fake. if they are real, I might just be his hero:).
Ok heres the sccop. The serial number is a fake and the clubs are not authentic. For anyone looking to buy off the internet, DONT. The Ping representative told me flat out that very few internet sales are legitamate.
The seller web address is. dot com. My neighbor is showing me all of the workmanship errors and mishaps so that I will now know how to spot fake clubs. If you do order clubs on line, call ping and verify serial numbers before you pay. Good luck, and thanks GJbenn85 for your help.:).
Originally Posted by cairtaker For anyone looking to buy off the internet, DONT. No.that is bad advice. Don't buy from companoies that offer clubs at ridiculous prices and have website with 50 obvious hallmarks of a scammer.
Simple rule - See if they offer clubs in left hand. If they are selling fakes, they won't. Although there are some clubs that aren't available in LH, (Mizuno MP63 for example) most are. If there is a row of rosettes and 'Live Help' icons down the bottom, you should exit immediately - that is if the obviously unrealistic prices don't tip you off.
Place like 3balls, Globalgolf are fantastic places to buy from. But.they don't sell current models at 80% of wholesale prices. Pretty simple, really. Yeah, there is no reason to not buy clubs online. There are PLENTY of retailers and even eBay sellers selling authentic clubs.
If the price is too good to be true, it is. Like anything else you buy online, just do research and use common sense. Nearly all of my clubs have been purchased online and they're the real thing, though I mostly buy from major retailers like Dick's, Golf Smith, etc. One little trick I use when trying to determine if a site is legitimate or not is to see if physical location information is readily available on the website.
Illegitimate sellers do not want to list their locations and usually only provide phone numbers, if that. Checking to see if left hand models are available as mentioned above is another good indicator if the clubs are real or knock-offs. Really only one putt yesterday I was really unhappy with. Hit a wedge into a par 3.
Was at least 20ft short of the hole. Crater for a ball mark where I landed and sucked it back that I had to putt back through. It was uphill then back down with 6” or so of left break coming back down. I hit the putt up and didn’t give it enough to get back down. Left it 3-4ft short. Never gave it a chance. Tough putt tho since you are coming downhill to the hole and don’t want to run it.
Still felt like being that short was a bad effort.
Verifying Ping Serial Numbers
Please enter your search criteria using the form below. You may enter keyword(s) separated by spaces, or phrases enclosed in double quotes to refine your search. If you cannot find the answer you are looking for, you will be given the option to submit a question after performing a keyword search. Product Model Category Keywords Displaying Search Results:1 to 30 of 237 matching records.
Or jump to page Click the question summary for the complete question and answer. Question Answer. The 'Ranger Cap' was a Limited Edition item that was only offered/available for a limited time last fall (2007) and it is no longer offered/. Samsung kies lite free download for windows 7.
Question Answer. Question Answer Shaft angle and lie angle are the same thing - the standard lie angle for all PING putters is 20 degrees from vertical. Question Answer First of all, I am sorry to hear about this. We are not allowed to send out the back-weights. This is because there are many different weights and we. Question Answer The swing weights of the i3 irons can be adjusted (within certain limitations), and the clubs would need to be sent to us for the adjustment.
Question Answer The swing weights of the irons can be adjusted (within certain limitations), and the clubs would need to be sent to us for the adjustment. Question Answer Yes, we can re-tumble the iron heads. This service is not available on any irons made of copper or nickel (BeCu, BeNi). This service does include buff.
Question Answer Please click on this link, complete the form in your browser, then print it and have it attested by your playing partners and golf professional. Question Answer Actually, the new PING RAPTURE line is 'in addition to' the very popular PING G5 and PING i5 lines. Question Answer The new PING RAPTURE line is estimated to begin shipping September 1, 2006, to those pro shops/retailers that have placed orders for them, and oldest. Question Answer PING does not sell direct to the consumer. Our clubs are priced individually, and replacements/fill-ins can be ordered through a local golf professio. Question Answer The new PING RAPTURE line is estimated to begin shipping September 1, 2006, to those pro shops/retailers that have placed orders for them, and oldest.
Question Answer Please see the Maximum Lie Angle Adjustability chart on the page of our site. The cost for lie angle.
Question Answer With the PING Fitting System the proper shaft length depends largely on your height. Generally taller golfers require longer clubs while shorter golf. Question Answer Here is some information on some of the most recent PING iron shafts. CS-LITE (Regular & Stiff): Weight: 93.9 (R), 107.3 (S) Torque: 1.8 (R), 1.7 (. Question Answer PING has a relationship with all shaft manufacturers and it is our policy to purchase shafts directly from them. We do offer shaft stabilization. Question Answer In our older model irons: K1,K2,K3,K3A,Eye,Eye2,Eye2+,Zing,Zing2,ISI,ISI-K, ISI-S, PING will only install graphite shafts in irons that were.
Question Answer Our Repair department can retumble the head of the putter to give it a finish much like the original finish. PING maintains a Repair department here a. Question Answer The standard lie angles of the TiSI Tec fairway woods are: #3 = 58.50 #5 = 59.00 #7 = 59.50. Question Answer It is possible to have a hosel change made in the PING TiSI/TiSI Tec/Si3 driver. The hosel and shaft are removed, and the old hosel and shaft are not. Question Answer Yes, we can reshaft from graphite to steel in the Ti3 fairway woods. It does require a sole weight change because of the changes in swing weight, i. Download death note 2 the last name torrent.
Question Answer No. The bags pictured on the web site are the only colors for this year's standard-production line of PING bags. All of the carry bags come with the. Question Answer The insets are made of different materials to give different feel. The Isoforce putters have metal pixel insets, the Isopur putters have a poured elas.
Question Answer The putter you are referring to is the PING 1-A putter. The PING 1-A putters are still in production, and can be ordered new through any local PING r. Question Answer For information regarding PING Bag repairs, please contact Lily Parnoth at (602)687-5706. She can let you know what can be done and how to go about i. Question Answer The G5 driver is available in 5 lofts (7.5, 9, 10.5, 12 and 13.5), 3 shafts (Aldila NV, TFC 100, Grafalloy Prolaunch), 5 shaft flexes (L, Soft-R, R, S. Question Answer We have a bag called the Moon bag. It is extremely light weight at 1.2 pounds and can accomodate a full set of clubs if needed.
Ping Golf Club Serial Numbers
This bag can also be s. Question Answer The PING 1-A putters were the putters that started it all.
Ping Golf
The PING 1-A putters were introduced in 1959, are still in production to this day, and can. Question Answer All of our equipment and accessories can be purchased through any local golf course, driving range or golf store pro shop that has an account with PIN. Question Answer The stainless steel I3+, I3, EYE2+, ZING2, ISI-S and ISI-K irons are still fully available, in sets or as few as one club at a time.
Any authorized P. Displaying Search Results:1 to 30 of 237 matching records. Or jump to page.
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |